The Ford F-150 is one in every of Ford’s hottest truck. It has quite a lot of engine sizes relying on the 12 months of the truck. All of the engines are run with a serpentine (accent or drive) belt. The serpentine belt is a crucial piece of the engine and the engine is not going to run with out it. The serpentine belt, nonetheless, isn’t a troublesome half to take away and set up. To take action takes lower than half an hour if you understand what you’re doing.
Ford F-150 Change the Serpentine Belt Directions
Park the Ford F-150 on a flat surface and open the hood.
Remove the cooling fan stator. That is just for 6.0 L engines. Remove the cooling fan mounting bolts. This may be accomplished with the socket wrench set. Remove the 4 stator mounting bolts with the socket after which take away the stator. Proceed to Step 6.
Remove the higher radiator hose. This step is just for 7.3 L engines. Place the drain pan below the radiator hose and take away the hose clamp with the screwdriver. Pull the radiator hose off of the radiator. Proceed to Step 6.
Remove the air duct. That is for 5.4 L and 6.8 L engines solely. The air duct is connected to the air cleaner assembly and might be eliminated with the socket wrench set. Proceed to Step 6.
Remove the fan assembly. That is for 4.6 L engines solely. Remove the fan assembly with the particular Ford fan instruments. After the the fan assembly is eliminated, transfer it over the shroud, away from the engine.
Remove the serpentine belt. To take away the serpentine belt, launch the pressure on the belt with the tensioner pulley. Put the tensioner bar or the socket wrench with the breaker bar on the tensioner pulley and pull to alleviate stress. The belt will then slip off.
Install the new belt. The brand new belt will slot in proper the place the previous one was and it’s a must to use the tensioner pulley to place it on fully. Reattach any elements that you just removed.
[taken from ehow.com]
